Since I used sealed bearings I will still use the vent and will put a grease fitting in but wont run the extension to the back of the bus.
Subscribe to:
Post Comments (Atom)
skip to main |
skip to sidebar
Disclaimer, I don't have a clue what I am doing! This blog is for your entertainment only so please don't try to hold me liable for you trying something as stupid as me. Thanks
Followers
Blog Archive
-
▼
2014
(63)
-
▼
February
(41)
- Pulley
- Fan belt pulley
- fan belt tensioner
- Bolted the alternator drive back in.
- Paint for the alternator drive.
- Ready for some primer
- reassembly
- drive bearings
- cleaned
- disassembly of fan and alternator drive block
- Fan drive back on bus
- Fan drive complete
- Fan drive paint
- vent
- epoxy plug
- fan drive
- I covered the bulkhead above the transmission wit...
- Frame mods
- alternater drive mount
- New tail light fixtures
- No latch
- Last two exterior doors
- Radiator line up
- Welding in the mounts for the radiator
- Temporary mounting the fan
- Mounting radiator
- Making a radiator mount from scratch
- engine
- engine right bank
- engine paint
- Got a set of valve covers off of Mannys old dd
- After a lot of searching I found a crankshaft hub.
- CHROME
- Fresh engine block from the machine shop
- Painting
- Oil pan
- A pair of heads is better than none!!
- I disassembled the blower I took off of Mannys eng...
- I tore down, cleaned, sandblasted, and painted the...
- I love how clean she is cause I know how little th...
- motor
-
▼
February
(41)
About Me
- Steve
- Ive been a cabinet maker for over 30 years now. I suppose some would call me a profesional cabinet maker as I make a living at it. I cant wait to get to the interior of the bus for this reason alone. Im going to do it up like the big boys do it.
No comments:
Post a Comment