After I fit it to the bus and marked the length, I cut it off and filled in the end and sealwelded it. Then I ground it off to finish it off.
Subscribe to:
Post Comments (Atom)
skip to main |
skip to sidebar
Disclaimer, I don't have a clue what I am doing! This blog is for your entertainment only so please don't try to hold me liable for you trying something as stupid as me. Thanks
Followers
Blog Archive
-
▼
2008
(223)
-
▼
March
(28)
- Windsheild header (Rust Bullet)
- Front end (Rust Bullet)
- Now I need a new bumper...lol.....
- Front drivers corner (steel is completed)
- Rust Bullet (bring on the rain)
- Winters rust storm...lol...
- Drivers side bumper support and storage bay floor.
- New bumper support with floor
- Drivers side wheel well completed
- Drivers side front slide out
- Filled in the hole
- Cut out the rusty hole
- Wire brushed the front crossmember
- Rust rear of spare tire support area
- Back side of bumper support
- Bye bye rusty parts
- New bumper support on the bus
- Filled in the end of the Bumper support corner
- Old piece vs new one.
- Template check??
- Wire brushed the bumper support.
- Bumper support all welded up
- Rough out of the replacement steel
- Right side up on the lower front corner.
- Front lower corners
- Weather, ......argh argh .......
- Gel-coat on the top, of the front cap.
- Top of the cap
-
▼
March
(28)
About Me
- Steve
- Ive been a cabinet maker for over 30 years now. I suppose some would call me a profesional cabinet maker as I make a living at it. I cant wait to get to the interior of the bus for this reason alone. Im going to do it up like the big boys do it.
No comments:
Post a Comment