I have dreaded cutting all this out for 1 and a half years now. It was intimidating to me because it holds up the whole rear of the bus.
Subscribe to:
Post Comments (Atom)
skip to main |
skip to sidebar
Disclaimer, I don't have a clue what I am doing! This blog is for your entertainment only so please don't try to hold me liable for you trying something as stupid as me. Thanks
Followers
Blog Archive
-
▼
2008
(223)
-
▼
June
(25)
- The jig vault ....lol......
- Engine compartment looking forward
- More new steel
- New steel
- Two to tie two together...lol...
- New passenger side fuel tank support
- last two cross members (better pic)
- Here is a couple of new cross members in the fab s...
- What have you done to the bus!!!!!
- The rust has left the bus for good!!!!!!!!!
- One tough Eagle...lol....
- Big bertha's at it again....lol...
- Carving up the rear of the bus.
- Above the drive axel from the drivers side.
- Looking up under the linkage tunnel between the dr...
- No wrenches needed to remove the engine...lol....
- Drive wheel
- From engine compartment
- Rust between drive wheel and boggie
- Boggie shock mount (pre-repair)
- Shock mount (pre repair)
- Gear linkages and grime
- Drivers side
- Rust, (pre-repair)
- Last of the rust pics.
-
▼
June
(25)
About Me
- Steve
- Ive been a cabinet maker for over 30 years now. I suppose some would call me a profesional cabinet maker as I make a living at it. I cant wait to get to the interior of the bus for this reason alone. Im going to do it up like the big boys do it.
No comments:
Post a Comment