I started by rounding a piece of 1 1/2 by 1/8 inch steel to fit the same radius I put on the wheel well plus 1/2 inch to get the finished bottom.
Subscribe to:
Post Comments (Atom)
skip to main |
skip to sidebar
Disclaimer, I don't have a clue what I am doing! This blog is for your entertainment only so please don't try to hold me liable for you trying something as stupid as me. Thanks
Followers
Blog Archive
-
▼
2009
(79)
-
▼
May
(14)
- Bed Slide out (allmost done)
- Start of the Bed slide out support system
- Right side up
- Bed slide Clamp
- Bed slide
- Bed slide
- Bed slide support rail
- Bed slide support track
- Bed Slide out actuator and motor
- Front drivers side Slide out in Rust Bullet
- Radius finished
- Slide out radius
- Slide out radius
- Front corner of drivers side front slide out
-
▼
May
(14)
About Me
- Steve
- Ive been a cabinet maker for over 30 years now. I suppose some would call me a profesional cabinet maker as I make a living at it. I cant wait to get to the interior of the bus for this reason alone. Im going to do it up like the big boys do it.
No comments:
Post a Comment