Subscribe to:
Post Comments (Atom)
skip to main |
skip to sidebar
Disclaimer, I don't have a clue what I am doing! This blog is for your entertainment only so please don't try to hold me liable for you trying something as stupid as me. Thanks
Followers
Blog Archive
-
▼
2012
(32)
-
▼
May
(26)
- Looking forward inside.
- I cut and fit most of the plywood last winter. ...
- Rear wall marine plywood and insulation in. On...
- Here's a sneak peek inside. I have been busy w...
- No title
- Drivers side cut and fit before deburing and ri...
- Curb side.....
- Filler up!!!! Deb says its time to hit the roa...
- Mirror finish siding.
- Rear bay doors and siding pics.
- Siding and doors....
- Just more siding pics. Area at back of front c...
- Drip edge dry fit above rear compartment.
- 24 gauge stainless, I doubled back on it to mak...
- Rivet rivet rivet rivet.......sounds like a farm...
- Jamb side of the front door with the stainless ...
- This is a piece of stainless steal that I forme...
- Front door jamb side right after I drilled all ...
- Asphalt side of bays. Just what I wanted to do...
- I am skinning the bottom of the bays to keep ou...
- Inside hardware for bay doors. This was sure r...
- I tapped in a grease fitting for the hinge pins...
- A close up of the cam locks and inside handle. ...
- Here's a pic of the back side of the entrance d...
- Front door with the mirror siding and upper ski...
- front door
-
▼
May
(26)
About Me
- Steve
- Ive been a cabinet maker for over 30 years now. I suppose some would call me a profesional cabinet maker as I make a living at it. I cant wait to get to the interior of the bus for this reason alone. Im going to do it up like the big boys do it.
No comments:
Post a Comment