I used the other half of the 4 inch pipe to form the center of the upper radious and filled in all around with 11 gauge steel and seal welded everything and primered for temporary rust control.
Subscribe to:
Post Comments (Atom)
skip to main |
skip to sidebar
Disclaimer, I don't have a clue what I am doing! This blog is for your entertainment only so please don't try to hold me liable for you trying something as stupid as me. Thanks
Followers
Blog Archive
-
▼
2007
(139)
-
▼
April
(28)
- Drivers area
- column joint
- view of the top of steps
- A view from atop
- That 2 inches worked out just fine
- A little plating and primer
- Wheel well fill in
- The plan
- I got a plan
- Still, thinking on moving or cutting that support
- Now you see the 2 inch problem too
- Still working on that 2 inch problem though
- See this junction of steel
- Me, still contimplating the step issues
- Me, working out a plan for the steps
- detailing and finish welding
- looking down into drivers side storage bay area
- little debbie
- I think Deb may be admiring the new ceiling of the...
- Temporary steps
- Wheel wells
- New radiused hoops for the wheel wells
- ceiling grid
- ceiling grid
- Drivers side floor joist
- Drivers wall rear
- 4th slideout framing
- drivers side front slideout
-
▼
April
(28)
About Me
- Steve
- Ive been a cabinet maker for over 30 years now. I suppose some would call me a profesional cabinet maker as I make a living at it. I cant wait to get to the interior of the bus for this reason alone. Im going to do it up like the big boys do it.
No comments:
Post a Comment